Electrical Installation – Running the Electric to the Cabinet Print
This instructional guide will assist in the planning/installation associated with the Electrical Power Supply for our Acrylic Spas.
Each of our acrylic tubs have removable cabinet panels which cover the perimeter that is entire of bath tub.
Whenever running the electric through the spa, the access point in to the case doesn’t have become placed appropriate during the Control Pack location. Our spas usually do not come built with a hole that is pre-drilled electric so access may be through some of the case panels.*
*NOTE: We usually do not advise installing the electric by way of a case panel that is https://hookupwebsites.org/russian-dating/ situated in front side a Pump, Control Pack, Blower, or Gate Valve. These panels will need to be likely eliminated at some time for upkeep or servicing.
Selecting a spot
Whenever choosing where you can enter the case, do this in line with the after:
- safety (don’t create tripping hazards)
- access points for users to go into the bath tub
- step positioning
- cover opening position (bottom mount lifters could have the address remainder low beside the case)
- address lifter mounts
Producing an Access Point
A Spade Bit is not recommended since there are no pre-drilled holes, access through the panel is done using a Hole Saw for a clean cut. The perfect location to put an opening when it comes to cord, will be three to five ins up from the base associated with cabinet panel, and four to six ins in through the edge that is outside of case panel. Take note that the case panels have actually lumber insulating and framework foam inserts. You will need to avoid drilling through the timber framework as this will damage the support that is structural lumber provides.
We usually do not recommend approaching through the bottom for the spa. Then we suggest you take into consideration that you will not be able to slide the tub in any way if this is the most ideal route.
This could pose issue if something specialist is needed to access a region of the bath tub that is against an obstruction such as for example a wall or deck.
The Control Pack (where in actuality the electric is going to be connected) should be found behind one of several cabinet panels straight below your Topside Control Panel (exact location shall vary based on spa model).
There was enough space within the case to perform the energy cable through the access point to the Control Pack even as we try not to totally fill the cavity with spray foam. The ability cable will need to go into the Control Pack through the hand side that is left.
To learn more about linking the electric to your circuit breaker, please click on our solution “Electrical Installation – Correct Wiring for a 240V Supply“.
In the event that you need any further help, be sure to contact client provider.